* The top of the leg tube has more rim
notches than the bottom of the leg tube.
03
04
01
02
Page 3 of 7
ASSEMBLY INSTRUCTIONS
Blackjack LShaped
Corner Executive Desk
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Sort the feet into pairs, two sets of one large & one small foot for the
main desk legs. One set of two small feet for the return leg.
Slide two feet and two cross collar plugs (9) into the 4 way cross collar
(8), place the 4 way gasket (12) on top and fully tighten the two
M8x16mm bolts (21) into the collar (8).
Screw all glides (14) into the base of the feet, leaving the glides one turn
from tight (then they can be adjusted easily if the floor is uneven).
Place a leg pole tube (5) on top of a collar. Align the notch. Fully tighten
the M10x110 bolt (20), spring washer and flat washer through the collars.
Repeat for all leg assemblies.
