Page 2 of 5
Slide the large foot and T tube connector into the collar, place the 150°
gasket on top, and fully tighten the 2 M8x16mm bolts into the collar.
(Repeat with all 150° collars).
Using 2 T tubes, connect the assembled corner feet to the bottom T
connector, and fully tighten the 4 M8x16mm bolts.
(Repeat with all 150° feet).
Screw all glides into the base of the large feet, leaving the glides one
turn from tight (then they can be adjusted easily if the floor is uneven).
Place the steel strap onto the upper wrists, with the raised areas of the
straps slotting into the holes on the upper wrist, Fig A. Fully tighten the
M8x25mm bolts. (Repeat with all upper wrists and steel straps)
01
02
03
04
Fig A
ASSEMBLY INSTRUCTIONS
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs
