Page 4 of 4
INSTALLATION GUIDE
Switch System
Small Round Meeting Table
Size: 700mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Position as presented, and proceed to screw to ensure each corner of the frame.
05
If this bolt does not drop into the joint
use the Allen key to screw it all the way
in so that it creates its own thread.
This will ensure a nice, tight joint.
Directly screw into table tops, using L-Bracket
screws through each L-Bracket.
06
Note:
It is important to fully tighten all bolts and screws before attaching
the top(s) so that the frame is sufficiently rigid. Failure to do this may
affect stability once the tops are attached.
