9
• ( ) Do not use this appliance near the water contained
in bathtubs, washbasins or other containers.
• When used in a bathroom, disconnect after use. The proximity
of water represents a danger even when the dryer is off.
• To ensure a complementary protection it is advisable to
install in the electrical circuit of the bathroom a residual
differential current device (DDR) of differential current of
assigned capacity that does not exceed 30 mA. Ask your
supplier for advice.
• Allow it to cool before storing.
• This appliance is designed for domestic use only.
• The cleaning and maintenance done by users, can not be
done by children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTIONS OF USE
• Open the foldable handle (5).
• The hair dryer has two switches that control the heat and one pusher for the airflow.
• Connect the appliance to the mains.
• Push the power switch (4) to any of its two positions (I or II) to obtain a greater or lesser airflow.
• Next push the power switch (3) to any of its positions (I – II or II) to obtain different heat levels.
• The combination of both switches will give you a wide range of options as to the airflow and the
heat of the air.
• If you wish to use only cold air while it is on, press the cold air switch (2).
• The air concentrator (7) and the diffuser (8) are placed, onto the hair dryer nozzle, with a slight
pressure.
IONISATION FUNCTION
The hair dryer is equipped with ions generator.
These ions remove the statical electricity of the hair, causes the division of the water particles in
micro particles, helping to a quick and natural absorption, having a extraordinary finish and
brightness for the hair.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning disconnect the appliance from the mains.
• You may clean it with a damp cloth and dry carefully afterwards.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the
surfaces of the appliance.
• It is very important to keep the air intake (1) and outlet grids always clean.
• Clean them frequently of any hairs or dust, which may get stuck to them.
