AT-268
[RE4F04B]
ON-VEHICLE SERVICE
Revision: November 2006
2006 Altima
6.
Remove control valve assembly by removing bolts I , X and
●
.
Bolt length, number and location are shown in the illustration.
CAUTION:
Do not drop manual valve and servo release accumulator return
spring.
7.
Disassemble and inspect control valve assembly if necessary.
Refer to
AT-306, "Control Valve Assembly"
8.
Remove servo release and N-D accumulators by applying com-
pressed air if necessary.
NOTE:
Hold each piston with a rag.
INSTALLATION
Installation is in the reverse order of removal.
●
Set manual shaft in Neutral, then align manual plate with groove
in manual valve.
●
After installing control valve assembly, make sure that selector
lever can be moved to all positions.
SAT004F
AAT279
SAT091J