REPAIR FOR COMPONENT PARTS
AT-303
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
4.
Remove O-ring from oil pump housing.
CAUTION:
Do not reuse O-rings.
5.
Remove oil pump housing oil seal using suitable tool.
CAUTION:
Do not reuse oil seal.
INSPECTION
Oil Pump Housing, Oil Pump Cover, Inner Gear and Outer Gear
Check component parts for wear or damage. Replace if necessary.
Side Clearances
Measure side clearance of inner and outer gears in at least four
places around each outside edge. Maximum measured values
should be within specified positions.
If clearance is less then specification, select inner and outer gear as
a set so that clearance is within specifications.
If clearance is more than standard, replace whole oil pump assembly
except oil pump cover.
SAT093D
SAT094D
Standard clearance
: 0.030 - 0.050 mm
(0.0012 - 0.0020 in)
Inner and outer gear:
Refer to
AT-378, "SERVICE DATA AND SPECIFICA-
.
SAT095D