REPAIR FOR COMPONENT PARTS
AT-331
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
Forward Clutch and Overrun Clutch Dish Plates
●
Check for deformation or damage.
●
Measure thickness of dish plate.
●
If deformed or fatigued, replace.
Forward Clutch Drum
●
Make sure that check balls are not stuck.
●
Apply compressed air to check ball oil hole from outside of for-
ward clutch drum. Make sure air leaks past ball.
●
Apply compressed air to oil hole from inside of forward clutch
drum. Make sure there is no air leakage.
Overrun Clutch Piston
●
Make sure that check balls are not stuck.
●
Apply compressed air to check ball oil hole opposite the return
spring. Make sure there is no air leakage.
●
Apply compressed air to oil hole on return spring side. Make
sure that air leaks past ball.
ASSEMBLY
1.
Install new D-rings and new seal rings on forward clutch piston
and overrun clutch piston.
CAUTION:
●
Do not reuse D-rings and seal rings.
●
Apply ATF to new D-rings and new seal rings.
●
Take care with the direction of new D-rings and new seal
rings.
Thickness of dish plate
Forward clutch
: 2.7 mm (0.106 in)
Overrun clutch
: 2.7 mm (0.106 in)
SAT163D
SAT213D
SAT212D
SCIA3046E