REPAIR FOR COMPONENT PARTS
AT-335
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
2.
In order to remove piston, apply compressed air to oil hole of
retainer while holding piston.
CAUTION:
Apply compressed air gradually to allow the piston to come
out evenly.
3.
Remove D-rings from piston and discard.
CAUTION:
Do not reuse D-rings.
INSPECTION
Low and Reverse Brake Snap Ring, Spring Retainer and Return Springs
●
Check for deformation, replace if fatigue or damage.
●
Always replace the spring retainer and return springs as a set.
Low and Reverse Brake Drive Plate
●
Check facing for burns, cracks or damage.
●
Measure thickness of facing.
●
If not within wear limit, replace.
ASSEMBLY
1.
Install new D-rings on piston.
CAUTION:
●
Do not reuse D-rings.
●
Apply ATF to new D-rings.
SAT149F
SAT150F
Thickness of drive plate
Standard value
: 1.8 mm (0.071 in)
Wear limit
: 1.6 mm (0.063 in)
SAT162D
SAT150F