REPAIR FOR COMPONENT PARTS
AT-343
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
8.
Remove reduction pinion gear bearing outer race from transaxle
case using suitable tool.
INSPECTION
Output Shaft, Idler Gear and Reduction Pinion Gear
●
Check shafts for cracks, wear or bending.
●
Check gears for wear, chips and cracks.
Bearing
●
Make sure bearings roll freely and free from noise, cracks, pit-
ting or wear.
●
Always replace roller bearing inner and outer races as a set.
Seal Ring Clearance
●
Install new seal rings to output shaft.
●
Measure clearance between seal ring and ring groove of output
shaft.
●
If not within allowable limit, replace output shaft.
●
Install new seal rings to bearing retainer.
●
Measure clearance between seal ring and ring groove of bear-
ing retainer.
●
If not within allowable limit, replace bearing retainer.
SAT319K
SPD715
Standard clearance
: 0.10 - 0.25 mm
(0.0039 - 0.0098 in)
Allowable limit
: 0.25 mm (0.0098 in)
Standard clearance
: 0.10 - 0.30 mm (0.0039 - 0.0118 in)
Allowable limit
: 0.30 mm (0.0118 in)
SAT171F