AT-360
[RE4F04B]
ASSEMBLY
Revision: November 2006
2006 Altima
3.
Install reduction gear and reduction gear bearing adjusting shim
selected in step 2-e on transaxle case.
4.
Press idler gear bearing inner race on idler gear.
5.
Install idler gear on reduction gear using Tool.
CAUTION:
Press idler gear until idler gear fully contacts adjusting
shim.
6.
Tighten idler gear lock nut to the specified torque using suitable
tool. Refer to
.
CAUTION:
Lock idler gear with parking pawl when tightening lock nut.
7.
Measure turning torque of reduction pinion gear using Tool.
●
When measuring turning torque, turn the reduction pin-
ion gear in both directions several times to seat bearing
rollers correctly.
●
If turning torque is out of specification, select the correct
reduction pinion gear adjusting shim.
8.
After properly adjusting turning torque, clinch idler gear lock nut
as shown.
Tool number
: ST35271000 (J-26091)
SCIA5402E
SAT189F
Tool number
: ST3127S000 (J-25765-A)
Turning torque of
reduction pinion gear
: 0.05 - 0.39 N-m (0.5 - 4.0 kg-cm,
0.43 - 3.47 in-lb)
WCIA0378E
SAT699D