ASSEMBLY
AT-363
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
2.
Set side cover on transaxle case using suitable tool.
CAUTION:
Apply locking sealant to the mating surface of transaxle
case.
3.
Tighten side cover bolts to specified torque. Refer to
CAUTION:
●
Do not mix bolts A and B.
●
Do not reuse bolts A as they are self-sealing bolts.
4.
Remove paper rolled around bearing retainer.
5.
Install thrust washer on bearing retainer.
CAUTION:
Apply petroleum jelly to thrust washer.
6.
Install forward clutch assembly.
CAUTION:
●
Align teeth of low & reverse brake drive plates before
installing.
●
Make sure that bearing retainer seal rings are not spread.
●
If forward clutch assembly is correctly seated, points 1
and 2 are at almost same level.
SAT442D
AAT850
SAT033F
SAT194F