TROUBLE DIAGNOSIS
AT-463
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
●
For details, refer to the separate “CONSULT-II Operations Man-
ual”.
1.
Turn ignition switch “OFF”.
2.
Connect CONSULT-II and CONSULT-II CONVERTER to data
link connector, which is located in driver instrument panel
(lower).
3.
Turn ignition switch “ON”. (Do not start engine.)
4.
Touch “START (NISSAN BASED VHCL)”.
5.
Touch “A/T”.
If “A/T” is not indicated, go to
GI-39, "Consult-II Data Link Con-
.
6.
Perform each diagnostic test mode according to each service
procedure.
WORK SUPPORT MODE
Work item
SELF-DIAG RESULT MODE
Operation procedure
1.
Perform “CONSULT-II SETTING PROCEDURE”. Refer to
AT-462, "CONSULT-II SETTING PROCE-
LCIA0042E
BCIA0029E
BCIA0030E
Work item
Condition
Usage
INITIALIZATION
Under the following conditions.
●
Ignition switch “ON”.
●
Selector lever “P” or “N” position.
●
Engine not running.
●
Vehicle speed is 0 km/h (0 MPH).
●
Ignition voltage is more than 10.5V.
●
Malfunction was not detected.
Use to initialize TCM in a case of replacing tran-
saxle or TCM. Refer to
A/T Assembly or TCM Replacement"
.
