TROUBLE DIAGNOSIS
AT-465
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
*1: Refer to
AT-430, "Malfunction Indicator Lamp (MIL)"
*2: These malfunctions cannot be displayed MIL if another malfunction is assigned to MIL.
*3: Indicate it when performing TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS). Refer to
.
*4: If DTC U1000 is displayed with other DTCs, first perform the trouble diagnosis for DTC U1000. Refer to
DATA MONITOR MODE
Operation procedure
1.
Perform “CONSULT-II SETTING PROCEDURE”. Refer to
AT-462, "CONSULT-II SETTING PROCE-
2.
Touch “DATA MONITOR”.
NOTE:
When malfunction is detected, CONSULT-II performs REAL-TIME DIAGNOSIS.
Also, any malfunction detected while in this mode will be displayed at real time.
PC SOL A(L/
PRESS)
●
Normal voltage is not applied to solenoid due to open,
short, and so on.
●
TCM detects as irregular by comparing target value with
monitor value.
X
P0745
P0745
SHIFT SOL A
X
P0750
P0750
SHIFT SOL B
X
P0755
P0755
SHIFT SOL C
X
P0760
P0760
SFT SOL C STUCK
ON
●
Condition of shift solenoid valve C is different from monitor
value, and relation between gear position and actual gear
ratio is irregular.
X
P0762
P0762
*2
SHIFT SOL D
●
Normal voltage is not applied to solenoid due to open,
short, and so on.
●
TCM detects as irregular by comparing target value with
monitor value.
X
P0765
P0765
SHIFT SOL E
X
P0770
P0770
PC SOL B(SFT/
PRS)
X
P0775
P0775
SHIFT
●
No rotation change occurs between input (turbine revolu-
tion sensor) and output (revolution sensor) and shifting
time is long.
●
Shifting ends immediately.
●
Condition in malfunction engine revs up usually shifting.
X
P0780
P0780
*2
PC SOL
C(TCC&SFT)
●
Normal voltage is not applied to solenoid due to open,
short, and so on.
●
TCM detects as irregular by comparing target value with
monitor value.
X
P0795
P0795
PC SOL C STC ON
●
Condition of pressure control solenoid valve C is different
from monitor value, and relation between gear position
and actual gear ratio or lock-up status is irregular.
X
P0797
P0797
*2
MANUAL MODE
SWITCH
●
Manual mode switch signal is incorrectly input due to
open, short, and so on.
—
P0826
—
TCM POWER INPT
SIG
●
Voltage supplied to TCM is too low.
—
P0882
P0882
ELEC TH CON-
TROL
●
The electric throttle control system for ECM is in a mal-
function, after that TCM inputs the result by CAN commni-
cation.
X
P1726
P1726
NO DTC IS
DETECTED.
FURTHER TEST-
ING MAY BE
REQUIRED.
●
No NG item has been detected.
—
X
X
Items (CONSULT-II
screen terms)
Malfunction is detected when...
TCM self-diagnosis
OBD-II (DTC)
A/T CHECK
indicator
lamp
*3
“TRANSMIS-
SION” with
CONSULT-II
MIL indicator
lamp
*1
,
“ENGINE” with
CONSULT-II or
GST