TROUBLE DIAGNOSIS
AT-469
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
Diagnostic procedure
1.
CHECK A/T CHECK INDICATOR LAMP
1.
Start the engine with selector lever in “P” position. Warm engine to normal operating temperature.
2.
Turn ignition switch “ON” and “OFF” at least twice, then leave it in the “OFF” position.
3.
Wait 10 seconds.
4.
Turn ignition switch “ON”. (Do not start engine.)
5.
Does A/T CHECK indicator lamp come on for about 2 seconds?
Yes or No
Yes
>> GO TO 2.
AT-598, "A/T CHECK Indicator Lamp does not come on"
2.
JUDGEMENT PROCEDURE
NOTE:
After turning ignition switch “ON” (at step 6), perform within 2 seconds (while A/T CHECK indicator lamp come
on.).
1.
Turn ignition switch “OFF”.
2.
Push shift lock release button.
3.
Move selector lever from “P” to “D” position.
4.
Release accelerator pedal. (Set the closed throttle position signal “ON”.)
5.
Depress brake pedal. (Stop lamp switch signal “ON”.)
6.
Turn ignition switch “ON”. (Do not start engine.)
7.
Move the selector lever to the “N” position and release brake pedal. (Stop lamp switch signal “OFF”.)
8.
Move the selector lever to “D” position and depress brake pedal. (Stop lamp switch signal “ON”.)
9.
Release brake pedal. (Stop lamp switch signal “OFF”.)
10. Depress accelerator pedal fully and release it.
>> GO TO 3.
3.
CHECK SELF-DIAGNOSIS CODE
Check A/T CHECK indicator lamp. Refer to
AT-470, "Judgement self-diagnosis code"
.
If the system does not go into self-diagnostics, refer to
AT-617, "TCM Self-diagnosis Does Not Activate"
.
>> DIAGNOSIS END