ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION
AT-47
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
7.
Touch “ERASE”. (The DTC in the ECM will be erased.)
HOW TO ERASE DTC (WITH GST)
1.
If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 10
seconds and then turn it ON (engine stopped) again.
2.
Perform “OBD-II SELF-DIAGNOSTIC PROCEDURE (No Tools)”. Refer to
. (The engine warm-up step can be skipped when performing the
diagnosis only to erase the DTC.)
3.
Select Mode 4 with Generic Scan Tool (GST). For details, refer to
.
HOW TO ERASE DTC (NO TOOLS)
1.
If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 10
seconds and then turn it ON (engine stopped) again.
2.
Perform “TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS)”. Refer to
. (The engine warm-up step can be skipped when performing the
diagnosis only to erase the DTC.)
WCIA0361E