AT-482
[RE5F22A]
DTC P0705 PARK/NEUTRAL POSITION SWITCH
Revision: November 2006
2006 Altima
4.
DETECT MALFUNCTIONING ITEM
Check the following.
●
Open or short-circuit in the harness between TCM and PNP switch A, B, C, PA.
●
Open or short-circuit in the harness for ground of PNP switch.
●
PNP switch. Refer to
AT-482, "Component Inspection"
.
OK or NG
OK
>> GO TO 6.
NG
>> Repair or replace damaged parts.
5.
CHECK DTC
Perform “DTC Confirmation Procedure”. Refer to
AT-478, "DTC Confirmation Procedure"
.
OK or NG
OK >> INSPECTION END
NG
>> GO TO 6.
6.
CHECK TCM
1.
Check TCM input/output signal. Refer to
AT-459, "TCM Input/Output Signal Reference Values"
2.
If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK
>> INSPECTION END
NG
>> Repair or replace damaged parts.
Component Inspection
ECS009DX
PNP SWITCH
1.
Check continuity between PNP switch terminals while moving selector lever. Refer to the following table.
2.
If NG, check again with control cable disconnected. (Refer to Step 1 above.)
3.
If OK on step 2, adjust control cable. Refer to
AT-628, "Control Cable Adjustment"
4.
If NG on step 2, remove park/neutral position (PNP) switch from A/T and check continuity of park/neutral
position (PNP) switch terminals. (Refer to step 1 above.)
5.
If OK on step 4, adjust park/neutral position (PNP) switch. Refer to
AT-626, "Park/Neutral Position (PNP)
6.
If NG on step 4, replace park/neutral position (PNP) switch.
SCIA2825E