AT-532
[RE5F22A]
DTC P0745 PRESSURE CONTROL SOLENOID VALVE A (LINE PRESSURE)
Revision: November 2006
2006 Altima
DTC P0745 PRESSURE CONTROL SOLENOID VALVE A (LINE PRESSURE)
PFP:31940
Description
ECS009FV
●
The pressure control solenoid valve A is normally high, 3-port
linear pressure control solenoid.
●
The pressure control solenoid valve A regulates the oil pump
discharge pressure to suit the driving condition in response to a
signal sent from the TCM.
On Board Diagnosis Logic
ECS009FW
●
This is an OBD-II self-diagnostic item.
●
Diagnostic trouble code “PC SOL A(L/PRESS)” with CONSULT-II or P0745 without CONSULT-II is
detected under the following conditions.
–
When normal voltage is not applied to solenoid due to open, short, and so on.
–
When TCM detects as irregular by comparing target value with monitor value.
Possible Cause
ECS009FX
●
Harness or connectors
(The solenoid circuit is open or shorted.)
●
Pressure control solenoid valve A
DTC Confirmation Procedure
ECS009FY
NOTE:
If “DTC Confirmation Procedure” has been previously performed, always turn ignition switch “OFF”
and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch “ON”. (Do not start engine.)
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Start engine.
4.
Run engine for at least 13 consecutive seconds at idle speed.
5.
If DTC is detected, go to
AT-534, "Diagnostic Procedure"
.
WITH GST
Follow the procedure “With CONSULT-II”.
SCIA2831E
BCIA0030E