AT-54
[RE4F04B]
ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION
Revision: November 2006
2006 Altima
X: Applicable
—: Not applicable
: Option
DTC WORK SUPPORT MODE WITH CONSULT-II
CONSULT-II Setting Procedure
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be
detected in self-diagnosis depending on control unit which carry out CAN communication.
1.
Turn ignition switch OFF.
2.
Connect CONSULT-II and CONSULT-II CONVERTER to data
link connector, which is located in left side dash panel.
3.
Turn ignition switch ON. (Do not start engine)
4.
Touch “START (NISSAN BASED VHCL)”.
Frequency [Hz]
—
—
●
Value measured by
pulse probe is dis-
played. If measure-
ment is impossible,
"#" sign is displayed.
"#" sign is also dis-
played at the final
data value until the
measurement result
is obtained.
DUTY-HI
—
—
●
Duty cycle value for
measurement probe
is displayed.
DUTY-LOW
—
—
PLS WIDTH-HI
—
—
●
Measured pulse
width of measure-
ment probe is dis-
played.
PLS WIDTH-LOW
—
—
Item
Display
Monitor item
Description
Remarks
TCM
Input
signals
Main
signals
Selec-
tion
from
menu
LCIA0042E
BCIA0029E