AT-540
[RE5F22A]
DTC P0750 SHIFT SOLENOID VALVE A
Revision: November 2006
2006 Altima
3.
CHECK TERMINAL CORD ASSEMBLY WITH SHIFT SOLENOID VALVE A
1.
Turn ignition switch “OFF”.
2.
Disconnect terminal cord assembly harness connector.
3.
Check resistance between terminal 2 and ground.
OK or NG
OK
>> GO TO 4.
NG
>> GO TO 5.
4.
CHECK HARNESS BETWEEN TCM AND TERMINAL CORD ASSEMBLY
Check the following.
●
Open or short-circuit in the harness between TCM and terminal cord assembly.
OK or NG
OK
>> GO TO 7.
NG
>> Repair or replace damaged parts.
5.
CHECK SHIFT SOLENOID VALVE A
1.
Remove side cover. Refer to
2.
Disconnect shift solenoid valve A harness connector.
3.
Check resistance between terminal 1 and ground.
OK or NG
OK
>> GO TO 6.
NG
>> Replace the control valve assembly. Refer to
6.
CHECK HARNESS BETWEEN TERMINAL CORD ASSEMBLY AND SHIFT SOLENOID VALVE A
Check the following.
●
Open or short-circuit in the harness between terminal cord assembly and shift solenoid valve A.
OK or NG
OK
>> GO TO 7.
NG
>> Repair or replace transmission wire. Refer to
AT-629, "Terminal Cord Assembly"
.
7.
CHECK DTC
Perform “DTC Confirmation Procedure”. Refer to
AT-537, "DTC Confirmation Procedure"
.
OK or NG
OK
>> INSPECTION END
NG
>> GO TO 8.
Connector
Terminal
Condition
Resistance
(Approx.)
F30
2 - Ground
Temperature: 20
°
C (68
°
F)
11 - 16
Ω
WCIA0449E
Connector
Terminal
Condition
Resistance (Approx.)
F100
1 - Ground
Temperature: 20
°
C (68
°
F)
11 - 16
Ω
SCIA4334E