AT-628
[RE5F22A]
ON-VEHICLE SERVICE
Revision: November 2006
2006 Altima
COMPONENT INSPECTION
1.
Make sure that ATF cooler valve is fully opened at room temper-
ature.
2.
Submerge ATF cooler valve in a water-filled container, and then
heat it up with temperature of over 82
°
C (180
°
F) for 10 minutes
more.
3.
Make sure that ATF cooler valve is fully closed.
Control Cable Adjustment
ECS009JE
Move selector lever from the P position to the D position. You should
be able to feel the detent in each position. If the detent cannot be felt
or the pointer indicating the position is improperly aligned, the control
cable needs adjustment.
1.
Place selector lever in the P position.
CAUTION:
Turn wheels more than 1/4 turn and apply the parking brake.
2.
Loosen control cable lock nut.
3.
Using the specified force, push control cable in the direction of
the arrow shown.
4.
Tighten control cable lock nut.
5.
Move selector lever from P to D position. Make sure that selector lever moves smoothly.
●
Make sure that the starter operates when the selector lever is placed in the N or P position.
●
Make sure that the transmission is locked properly when the selector lever is placed in the P
position.
Dimension “A”:
More than 72.0 mm (2.835 in)
A:
Distance between ATF cooler valve port end face
and valve shaft end face.
SCIA2711J
SCIA2993E
Dimension “A”:
Less than 66.5 mm (2.618 in)
A:
Distance between ATF cooler valve port end face
and valve shaft end face.
SCIA2711J
Specified force
: 9.8 N (1.0 kg, 2.2 lb)
BBIA0279E