AT-632
[RE5F22A]
REMOVAL AND INSTALLATION
Revision: November 2006
2006 Altima
Inspection After Removal
ECS009JJ
●
Check the drive plate runout as shown.
●
If this runout is out of allowance, replace drive plate and ring
gear. Refer to
AT-702, "SERVICE DATA AND SPECIFICATIONS
.
●
If the drive plate needs to be replaced, align the crankshaft
dowel pin with the correct hole on the drive plate. Refer to
CAUTION:
Do not allow any magnetic materials to contact the ring gear
teeth.
Installation
ECS009JK
CAUTION:
●
When replacing an engine or transmission you must make sure the dowels are installed correctly
during re-assembly.
●
Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of drive
train components.
1.
When connecting torque converter to transaxle, measure dis-
tance “A” to be certain that they are correctly assembled.
2.
Install the torque converter to drive plate.
NOTE:
With converter installed, rotate crankshaft several turns to check
that transaxle rotates freely without binding.
3.
Tighten bolts securing transaxle.
4.
Installation of the remaining components is in the reverse order
of removal.
NOTE:
To prevent mis-connect, revolution sensor harness connector is
color taped for identification.
SAT977H
Distance “A”
: 14.0 mm (0.551 in) or more
SAT044A
Torque converter to
drive plate bolts
: 49 - 58 N·m (5.0 - 5.9 kg-m,
37 - 42 ft-lb)
WCIA0070E
Bolt No.
Tightening torque
N·m (kg-m, ft-lb)
mm (in)
1
70 - 79 (7.2 - 8.0, 52 - 58)
55 (2.17)
2
41.2 - 52.0 (4.2 - 5.3, 31 - 38)
40 (1.57)
3
70 - 79 (7.2 - 8.0, 52 - 58)
55 (2.17)
SCIA3017E