ASSEMBLY
AT-371
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
c.
With original thrust washer installed on oil pump, place Tool legs
onto machined surface of oil pump assembly. Then allow
plunger to rest on thrust washer.
d.
Measure gap between cylinder and plunger with feeler gauge.
This measurement should give exact reverse clutch drum end
play.
●
If end play is out of specification, decrease or increase thick-
ness of thrust washer as necessary.
Assembly (3)
ECS009BI
1.
Install anchor end pin and lock nut on transaxle case.
2.
Place brake band on outside of reverse clutch drum. Tighten
anchor end pin just enough so that brake band is evenly fitted on
reverse clutch drum.
3.
Place bearing race selected in total end play adjustment step on
oil pump cover.
CAUTION:
Apply petroleum jelly to bearing race.
4.
Place thrust washer selected in reverse clutch end play step on
reverse clutch drum.
CAUTION:
Apply petroleum jelly to thrust washer.
5.
Install oil pump assembly, baffle plate and gasket on transaxle
case.
CAUTION:
Do not reuse gasket.
6.
Tighten oil pump bolts to the specified torque.
Reverse clutch drum
end play “T
2
”
: 0.55 - 0.90 mm
(0.0217 - 0.0354 in)
Available thrust washer
for adjusting reverse
clutch drum end play
"THRUST WASHERS FOR
ADJUSTING REVERSE
CLUTCH DRUM END
PLAY"
SAT221F
SAT196F
SAT013F
SAT012F