DTC P0500 VEHICLE SPEED SENSOR MTR
AT-475
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
Diagnostic Procedure
ECS009DL
1.
CHECK INPUT SIGNALS
With CONSULT-II
1.
Start engine.
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Drive vehicle, and then make sure that the values of “VHCL/S
SE-A/T” and “VHCL/S SE-MTR” are same.
OK or NG
OK
>> GO TO 4.
NG
>> GO TO 2.
2.
CHECK DTC WITH ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Refer to
(with ABS),
OK or NG
OK
>> GO TO 3.
NG
>> If NG, recheck pin terminals for damage or loose connection with harness connector.
3.
CHECK DTC WITH UNIFIED METER AND A/C AMP.
Refer to
.
OK or NG
OK
>> GO TO 4.
NG
>> If NG, recheck pin terminals for damage or loose connection with harness connector.
4.
CHECK DTC
Perform “DTC Confirmation Procedure”. Refer to
AT-474, "DTC Confirmation Procedure"
OK or NG
OK
>> INSPECTION END
NG
>> GO TO 5.
5.
CHECK TCM
1.
Check TCM input/output signal. Refer to
AT-459, "TCM Input/Output Signal Reference Values"
2.
If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK
>> INSPECTION END
NG
>> Repair or replace damaged parts.
SCIA2922E