DTC P0717 TURBINE REVOLUTION SENSOR CIRCUIT
AT-495
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
TCM terminals and data are reference value. Measured between each terminal and ground.
Diagnostic Procedure
ECS009EH
1.
CHECK TURBINE REVOLUTION SENSOR CIRCUIT
With CONSULT-II
1.
Start engine.
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Drive vehicle and read out the value of “TURBINE REV”.
Without CONSULT-II
1.
Start the engine.
2.
Check pulse between TCM connector terminals 23 and 30.
OK or NG
OK
>> GO TO 3.
NG
>> GO TO 2.
2.
DETECT MALFUNCTIONING ITEM
Check the following.
●
Open or short-circuit in the harness between TCM and turbine revolution sensor.
●
Turbine revolution sensor. Refer to
AT-496, "Component Inspection"
.
OK or NG
OK
>> GO TO 3.
NG
>> Repair or replace damaged parts.
Terminal
Wire
color
Item
Condition
Data (Approx.)
23
G
Turbine revolution
sensor power sup-
ply
When turning ignition switch ON.
Battery voltage
When turning ignition switch OFF.
0V
30
R
Turbine revolution
sensor
When moving at 20 km/h (12 MPH) in 1st gear.
371Hz
Monitor item
Condition
Specification
TURBINE REV
During driving (lock-up ON)
Approximately matches the
engine speed.
SCIA2924E
Connector
Terminal
Condition
Data
(Approx.)
F57
2 - 30 (ground)
When moving at 20 km/h (12
MPH) in 1st gear.
371 Hz
SCIA2925E