DTC P0775 PRESSURE CONTROL SOLENOID VALVE B (SHIFT PRESSURE)
AT-569
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
TCM terminals and data are reference value. Measured between each terminal and ground.
Diagnostic Procedure
ECS009HD
1.
CHECK PRESSURE CONTROL SOLENOID VALVE B SIGNAL
With CONSULT-II
1.
After warming up the engine and transaxle, turn ignition switch “OFF”.
2.
Turn ignition switch “ON”. (Do not start engine.)
3.
Select “DATA MONITOR” mode for “A/T” with CONSULT-II.
4.
Read out the value of “PC SOL B OUT” and “PC SOL B MON”.
Without CONSULT-II
1.
Start the engine.
2.
Check pulse between TCM connector terminals 21 and 36.
OK or NG
OK >> GO
TO
7.
NG
>> GO TO 2.
2.
CHECK PRESSURE CONTROL SOLENOID VALVE B CIRCUIT
1.
Turn ignition switch “OFF”.
2.
Disconnect the TCM connector.
3.
Check resistance between TCM connector terminals 21 and 36.
OK or NG
OK
>> GO TO 7.
NG
>> GO TO 3.
Terminal
Wire
color
Item
Condition
Data (Approx.)
21
G/B
Pressure control
solenoid valve B
ground
When engine is running with idle speed and set-
ting selector lever to “P” position.
0V
36
OR/B
Pressure control
solenoid valve B
When engine is running with idle speed and set-
ting selector lever to “P” position.
300Hz
Monitor item
Condition
Display value
(Approx.)
●
PC SOL B OUT
●
PC SOL B MON
Selector lever: Manual shift gate position
1.00 A
Other than the above.
0.30 A
SCIA2907E
Connector
Terminal
Condition
Data
(Approx.)
F57
36 - 21 (Ground)
When engine is running with idle
speed and setting selector lever
to “P” position.
300 Hz
SCIA2911E
Connector
Terminal (Wire color)
Condition
Resistance
(Approx.)
F57
36 - 21 (Ground)
Temperature: 20
°
C (68
°
F)
5.0 - 5.6
Ω
SCIA2912E