AT-626
[RE5F22A]
ON-VEHICLE SERVICE
Revision: November 2006
2006 Altima
ON-VEHICLE SERVICE
PFP:00000
Revolution Sensor Replacement
ECS009J9
1.
Remove intake air duct.
2.
Disconnect electrical connector.
3.
Remove revolution sensor from A/T.
CAUTION:
Do not damage the revolution sensor or transaxle case.
4.
Installation is in the reverse order of removal.
CAUTION:
Do not reuse seal bolt.
Turbine Revolution Sensor Replacement
ECS009JA
1.
Remove battery and bracket.
2.
Disconnect electrical connector.
3.
Remove bolt and turbine revolution sensor from A/T.
CAUTION:
Do not damage the turbine revolution sensor or transaxle
case.
4.
Installation is in the reverse order of removal.
CAUTION:
Do not reuse seal bolt.
Park/Neutral Position (PNP) Switch Adjustment
ECS009JB
1.
Remove battery and bracket.
2.
Remove cable from range lever.
3.
Set range lever in neutral position.
4.
Remove range lever and install Tool.
5.
Loosen park/neutral position (PNP) switch bolts.
6.
Adjust PNP switch so that Tool pointer aligns with neutral base
line on PNP switch body.
7.
Tighten PNP switch bolts.
8.
Reinstall range lever and cable.
9.
Adjust control cable. Refer to
AT-628, "Control Cable Adjust-
10. Reinstall battery and bracket.
11. Check continuity of PNP switch. Refer to
.
BBIA0272E
BBIA0273E
Tool number
: KV991J0060 (J-45404)
SCIA5374E
BBIA0274E