ii
UNITED STATES - FEDERAL COMMUNICATIONS COMMISSION
CONSUMER INFORMATION AND REQUIREMENTS
Part 15-Radio Interference
This equipment has been test and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC rules. These limits are design to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy if is not installed and used in accordance with the instructions. It is may
causes harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, please turning the it off is determination. The user
encouraged to try to correct the interference by one or more of the following measures:
1. Reorient the receiving antenna
2. Increase the separation between the equipment and the receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
4. Consult with the dealer or an experienced radio or television technician for help.
Notice 1:
The changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment
Notice 2:
Shielded interface cables and AC. power cord, if any, must be used in order to comply with
emission limits
Part 68 --Telephone Connection
This equipment complies with Part 68 of the FCC Rules. Inside this equipment was a label that
contains, among other things, the FCC Registration Number and Ringer Equipment Number (REN)
for this equipment. You must, upon request, provide this information to your telephone company.
The REN is useful to determine the quantity of devices you may connect to your telephone line and
still have all those devices ring when your telephone number might call. In most, but not all areas,
the sum of the REN's of all devices you may connect to one line should not exceed five (.5.0). To be
certain of the number of devices you may connect to your line, as determined by the REN. You
should contact your local telephone company to determine the maximum REN for your calling
area.
If your equipment cause harm to another telephone equipment, the Telephone Company may
discontinue your service temporarily. If possible, they will notify you in advance. Instead of
advance notification is not possible and you will be notify as soon as possible. You will be inform
of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or procedures
that would affect the proper functioning of your equipment. You
will be
notify in advance to give
you an opportunity to maintain uninterrupted telephone service.
Summary of Contents for Communicator V.90
