36
automatically setup the display frequency without loading video
driver. Try to turn it off, or change settings of monitor type in your
system.
Q:
Selection of color, resolution and refresh rate combination
that always back to default after restart the system.
A:
Accordingly, there must be a bug (defected source-code) in video
driver, or in the system. Debug the source-code or fix the error in
video driver, that should be done by the driver developer. Likewise,
upgrade the video driver from the manufacturer or from the original
software developer is necessary.
8.1 Tips
The following are some recommended steps to take if the video adapter
will not boot up or operate properly in your system:
1. Ensure that the monitor or TV brightness and contrast controls
are properly adjusted.
2. Check to see if your monitor or TV is properly connected to the
card. Be sure your monitor’s pin definitions match those of
your video card. For TV out, ensure that the composite signal
is connected to a “Video Input” RCA jack on the TV (or check
the S-video connection). Read the TV owner’s manual to
select the proper signal jack for the display.
3. Turn the system on and confirm that the power supply is
operating properly; i.e., that the fan operates and the system
power light turns on.
4. Check to see if the card is firmly seated in its AGP bus
expansion slot. It should not be making contact with any other
cards in the system.
Note
: Turn the system off before adjusting the card.
9. Video Mode Reference Table
The adapter’s video modes include all of the following:
Summary of Contents for Video-117PCI-16
Page 14: ...14 2 Tab to Settings screen then click on Advance button...
Page 15: ...15 3 Click on Next button with Advanced selectable option...
Page 21: ...21 2 SELECT the Settings tab screen...
Page 30: ...30 2 Click on Next button to continue 3 New Hardware Wizard searches device has been install...
