7
2-7. Controls on generator front panel
A
——
There is two mode for choice
Auto mode: after the welding torch and earth cable short circuit
or contact for 0.5s,the machine will output.
Manual mode: trigger on the torch, the machine will output.
B
——
Welding parameter save
Finish adjust welding mode and welding power, the user can
press "save”for save the setting.
C\D
——
welding function selection
Choice the welding mode, the system will auto match welding
power. And the power indicator display the power level 1-10 on
the right side.
E\F
——
Output power adjustment
The larger number the higher output power.
There are 10 level for welding power. In general operation, the
user only choice welding mode, the system will auto match welding
power. But the user can adjust it by themself. After adjust the welding setting, it will don’t cover the system
recommended setting. Till to press ”save”, the machine will save customer setting and cover the recommended
setting.(Keep to press the two buttons for 2 second, the welding setting will be recover factory defaults.)
G
——
Socket for work clamp
H
——
Control socket for torch
I
——
Socket for torch
J
——
Power switch
K
——
Input power cable
(Confirm the power voltage before use)
L
——
Ground connector for the machine case
M
——
Discharge indicator
When the indicator is light up, it means the machine charge is
finish, The machine can welding operation. After discharge
operation, the discharge indicator will light off for a few moment.
When the discharge indicator is light off, it means the machine is
charging. The time of light off will increase, following of the more
setting power. If in manual mode, the user trigger on the torch
Φ
4~5 steel stud
round washer/tab shooter
quick puller slide hammer
star washer/steel tab
triangle washer/ American stud
Φ 4~5 aluminum stud (optional function, only
for ALU type machine)
A
B
G H I
C D E F
M
N
O
J
P
K
L
