2
EN
ECCENTRIC FLARING KIT
01. Loosen the fixing rod before using.
Then pull and twist the rotary rod up to
the very top end.
02. Open the tube expander clip and place
a tube according to required dimension.
03. The tube should be higher than the
plane of the tube expander clip (about 1
m/m) and clean out the tube away from
impurities before operation.
04. Aim the red arrow in front of cone clip to
the required dimension mark. Then tight
lock the fixing rod.
05. Push the rotary rod and turn down. The
tube will loosen automatically after the
tube is expanded.
06. Pull and twist the rotary rod up to the
very top end. Be sure that backward
isn’t allowed until the center is beside
the rotary rod and it is placed inside in
the hole. Finally loosen the fixing rod to
open the tube expander clip and take
the tube out.
Tube expander clip
Arrow
Dimension mark
Tube
Tube expander clip
Fixing
rod
Tube
Expander
Clip
Tube
1mm
Twist
Pull
Turn
Push
Rotary
rod
JAV806B-2 JAVAC Eccentric Flaring Kit A5 Instructions.indd 2
13/12/2017 14:12
