How to setup HPT435BT JL to provide RTK data received via
NTRIP Client to UHF.
The purpose of this document is to describe how to configure HPT435BT JL to provide RTK data
received via NTRIP Client to UHF.
The following are the steps of configuration of JLink LTE:
Connect to HPT435BT JL via web interface (For more detail see document “HPT435BT JL
User Manual”).
Cellular (GSM ) configuration
◦
In the
Communication/GSM
tab. Set the PIN code and APN parameters (if necessary) (see
Picture 1).
◦
Please use tweezers to install or remove micro SIM card see (see Picture 2.a).
◦
Insert the SIM card to its slot. The first slot from the green top cover is for micro SIM, the
second slot is for micro SD (see Picture 2.b).
◦
In the
Communication/Power Management
tab activate the GSM interface (see Picture 3).
And wait for registering in the network and Internet access availability . Detailed connection
status you can check in
Status/GSM
tab (see Picture 4).
It is possible also to connect HPT435BT JL to Internet via LAN or Wi-Fi using any Wi-Fi router, MiFi
device or even smart-phone configured in hot spot mode.
Picture 1.
HPT435BT JL
GSM configuration tab
