www.javad.com
JNSGyro-2T Operator’s Manual
35
C O N F I G U R A T I O N
MinPad Configuration
Use PCView to configure MinPad settings. Refer to the
PCView Software Man-
ual
for all possible MinPad configurations.
1.
Connect selected board of your JNSGyro-2T and computer. See
“Connecting the JNSGyro-2T and a Computer” on page 27 for this
procedure.
2.
Start PCView.
3.
On the
Connection Parameters
dialog box, enable RTS/CTS handshaking
Connect
.
Figure 2-11. Connection Parameters – RTS/CTS Handshaking
4.
Click
Configuration->Receiver
(Figure 2-12).
Figure 2-12. Configuration->Receiver
5.
Click the
MinPad
tab, set the following parameters and click
Apply
(Figure 2-13 on page 36). See the following pages for descriptions of these
parameters.
• Recording interval on page 36
• Elevation mask for log file on page 36
• File name prefix on page 36
• Always append to the file on page 37