www.javad.com
JNSGyro-2T Operator’s Manual
39
C O N F I G U R A T I O N
MinPad Configuration
Table 2-1 gives the different scenarios available and the results after power is
restored to the board. “Specified file” refers to the file name entered in the
Always append to file parameter.
Table 2-1. Data Recording Parameter Behavior
Before Power
Failure
Enabled Radio Button Results
Off
On
Always
1
Board data
logged to file
specified.
Data logging will not
resume when power is
restored.
Board will resume data
logging to the same
file when power is
restored.
Board will resume data
logging to the same
file when power is
restored.
2
Board data
logged to
default file.
Data logging will not
resume when power is
restored.
A new log file will
open when power is
restored and data will
log to this file.
A new log file will
open when power is
restored and data will
log to this file.
3
File specified;
board data
logging not
started.
No file will open with
this name.
Data logging will not
start when power is
restored.
No file will open with
this name.
Data logging will not
start when power is
restored.
A log file with this
name will open and
data logging will start
after power is restored.
4
No file
specified;
board data
logging off.
Data logging will not
start when power is
restored.
Data logging will not
start when power is
restored.
A log file with a
default name will open
and data logging will
start after power is
restored.
Also, if
Always
is enabled, your board will automatically start logging data
(to a newly created or an existing file) in the following three cases:
• After pressing the
Power
key to turn on the unit.
• After resetting the unit (with PCView or the
Reset
key).