26
JNSGyro-2T Operator’s Manual
www.javad.com
C O N F I G U R A T I O N
Powering the JNSGyro-2T
2
Powering the JNSGyro-2T
Power supply requirements
A single external power supply with 5 pin ODU connector or SAE connector is
necessary to operate the JNS Gyro-2T. If external power supply has only SAE
connector, Receiver-to-SAE power cable shall be used. The external power
supply needs to be Listed for US and Certified for EU countries, it needs also to
be a Limited Power Source and rated for Outdoor Use and have an output rated
for 9-30 Vdc, 1.2 A. This may not be the same range as other JNS products with
which you are familiar.
CAUTION:
To avoid the introduction of hazards when operating
and installing, before connecting of the equipment to
the supply, make sure that the supply meets local and
national safety ordinances and matches the equip-
ment’s voltage and current requirements.
Never attempt any maintenance or cleaning of the sup-
ply while plugged in. Always remove supply from AC
power before attempting service or cleaning.
Warning: If the voltage supplied is below the minimum specifi-
cation, the receiver will suspend operation. If the volt-
age supplied is above the maximum specification, the
receiver may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped on, tripped over, or
otherwise subjected to damage or stress. Do not operate equipment with a
damaged cord or plug – replace immediately. To reduce the risk of damage
to the equipment, pull by the plug body rather than the output cord when
disconnecting the equipment.
Do not operate the supply if it has received a sharp blow, been dropped, or
otherwise damaged. Do not disassemble the supply.