www.javad.com
LGG100 Operator’s Manual
2-3
S E T U P A N D M E A S U R I N G
Connecting the LGG100 and a Computer
Once the receiver and a computer are connected, start PCView on your
computer.
The PCView main screen displays (Figure 2-1 on page 2-3).
Figure 2-1. PCView Main Window
Note that the lower-left hand corner shows the receiver status as
“Disconnected”.
On the
Connection Parameters
dialog box, select the following
parameters and click
Connect
–Set the
Connection mode
(Direct).
–Set the port for your computer (typically COM1, COM2 for RS232
connection) from the
Port
drop-down list.
–Set the communication rate between the receiver and the computer
(usually 115200) from the
Baud rate
drop-down list.
Summary of Contents for LGG100
