www.javad.com
Prego Operator’s Manual
3
-
13
S E T U P A N D M E A S U R I N G
Measuring with the Prego
Setting up an RTK Base Station
To configure a RTK Base station using PCView, take the following
steps:
1.Set up the Base station receiver’s antenna as described in “Setup
2.Connect an external modem to port C. The internal radio should
already have been configured.
3.Set up hardware as shown in Figure 3-8. This setup shows a Base
station setup.
Figure 3-8. Base Station Setup
Notice:
Connect the radio antenna before switching the modem to the
transmitting mode.
measuring
Plumb Base station
antenna over
measuring mark
Summary of Contents for Prego
