2-16
Prego Operator’s Manual
www.javad.com
C O N F I G U R A T I O N
Radio Configuration
2
1.
Once connected, click on
File->Manual Mode
to create a daisy chain
between the receiver’s port (A or D) and the Prego PDL modem.
Figure 2-19. File->Manual Mode
2.
Write each of the following commands, pressing
Enter
(or clicking
Send
command
) after each command (Figure 2-20 on page 2-17).
• %%set,dev/ser/c/rate,38400
• %%set,dev/ser/c/echo,/cur/term
• %%set,dev/ser/c/imode,echo
• %%set,cur/term/eoff,QUIT
• %%set,cur/term/echo,/dev/null
• %%set,cur/term/imode,echo
• %%set,cur/term/echo,/dev/ser/c
The Manual Mode screen will show RE002%% in response to each of these
commands. When finished, you should have seven responses (Figure 2-20
on page 2-17).
Tip: Save this set of commands to a script file
and load this file later to the receiver with a
single operation. To create a script file, see
Summary of Contents for Prego
