________________________________________________________________________________________________________________________________________________________________
CN3600 Setup & Operation Manual Revision : 6/2020
39
3.12 SPRAY SYSTEM
The Spray System (see
Fig. 3.12
) is for lubricating
and cooling the side of the knife to prevent adhesive
build up. The sprays work on a
Venturi System
.
The vacuum generator sucks water to form a mist.
NOTE: Adjust both sprays (with adjusting Knob) to sides
of knife approx 25mm from knife edge each time you
use different diameter knife.
Add approximately two and a half tablespoons full of a truck wash (CT18) or car wash
or similar product, to the water container (see
Fig. 3.12
). (We recommend using a
product which is as salt free as possible to reduce rust occurring.)
1.
Installation:
As shown in Fig 3.11, C is the water pipe and D is air pressure pipe. Both pipes
are 6mm O/D. The water pipe is connected into water container and then one
non-return valve is connected (E) (please note the direction of flow). The air
pressure pipe is connected to a solenoid valve.
2.
Adjustment:
As shown in the drawing below, A adjusts the water volume B adjusts the air
volume. Turn anti-clockwise for more water or air.
。
.Fig 3.12 Spray System
WATER CONTAINING
2½ TABLESPOONS OF
SALT FREE
DETERGENT (I.E.
TRUCK WASH (CT18))
WATER
DRAINING FROM
KNIFE GUARD
SPRAYS
NON RETURN VALVES (E)
RETAINS LUBRICANT IN
PIPES IN ORDER THAT SPRAY
STARTS IMMEDIATELY KNIFE
FORWARD MOVEMENT
COMMENCES AND BEFORE
KNIFE CONTACTS TAPE.
Adjusting Knobs
CLEAR-Water
ORANGE-Air
