User Manual Javo Rotofill
Version 2014-1-2
5
2
Safety
This machine is built according the state of the art technique and the accredited safety regulations. Despite
this, the body and life from the user or third parties can be in danger when using it. There could also arise
damage to the machine or other goods when using it.
This machine is CE marked. When placing multiple machines in one line, the entire line must be properly CE
marked before using this machine. Untill proper CE Marking of the line is carried out, commissioning of this
machine is prohibited.
2.1
Provisions
1.
Operation and maintenance of this machine must be performed by qualified personnel in compliance with
warnings on the machine and in accordance with the user manual. Keep children and other (unauthorized)
persons away while using machine.
2.
This machine is suitable for process and environmental conditions as stated in section "Specifications and
Tolerances" of this manual only. Any other use is not authorized by Javo BV and this allows the operator and /
or the environment at risk.
3.
It is prohibited to modify this machine, without prior written approval of Javo BV.
4.
Thermal fuses and torque limiters may not be set different upon delivery of the new machine. The thermal
circuit breakers should never be used to turn on / off the machine.
5.
This machine should be installed so that there is sufficient space remaining for providing safe instructions and /
or performing maintenance and / or inspections. Put the brakes on the castors before the machine is turned on.
6.
Keep the work area clean and well lit. Cluttered or dark areas invite accidents.
7.
This machine is not suitable to be used outside. Electrical components are only splashproof. Keep the machine
away from rain and moisture. When using the machine in a humid environment is unavoidable, you should use
an RCD.
8.
Keep hands, hair, loose clothing and / or jewelry away from moving parts of the machine. Wear appropriate
clothing without loose parts. Wear non-slip work shoes.
9.
As long as the machine is on, no connection or safety devices may be removed. The machine may only be used
when all protective devices and safety-related facilities are available and ready for use.
10.
Do not stand on the machine when it is operating.
11.
Never move the machine if the power cable and / or pneumatic supply is still connected.
12.
Prescribed checks and maintenance in the user manual must be observed.
13.
Allow the machine to be serviced and repaired by qualified personell only with original replacement parts.
14.
In addition to the user manual, generally applicable statutory and other regulations regarding accident
prevention and environmental protection have to be respected. This is also referred to handling of personal
protective equipment.
15.
Inform operating personnel before start maintenance. Interrupt if possible the power (mains), before start
machine investigation or maintenance by turning off the main switch and locking the main switch. Pull the plug
from the wall socket.
a.
As work must be done with power supply (mains) voltage on the machine, then arrange an
additional person who can operate the emergency stop.
16.
When a machine part is damaged or not working in the prescribed manner, the work must be interrupted
immediately. Resumption allowed only when the machine part is repaired or replaced and checked. Consult
your dealer if the machine is not functioning properly.
17.
Machine and / or parts must be disposed in accordance with local laws and regulations.
