Operator’s Manual
ATTACHING BUCKET OR OTHER ATTACHMENT
LOADERS WITH SKID-STEER TOOL CARRIER
WARNING: Use only buckets and attachments compatible with SAE J2513
standard. Use of other attachments does not guarantee safe connection of the
bucket with the loader. Serious injury or death may result. If unsure about the
attachment origin, contact a TYM dealer and ask for assistance.
CAUTION: Except when detaching or attaching bucket or other attachment, keep
the bucket latching handles in the LOCKED POSITION (handles in hor. position)
CAUTION:
To
maintain
proper
function
of the quick attach system, inspect the
latching
handles,
lockpins,
attachment coupler and attachment flange for damge
before attaching the bucket. If damage exists, replace component immediately.
CAUTION: Make sure all parts of the quick attach system are clean before
attaching the bucket. Only clean components will function safely.
1.
Move latching handles to the UNLOCKED
position (UP).
2.
Have the attachment coupler slightly tilted forward
Drive tractor centrally to the bucket. The top of the
attachment coupler must be aligned with the
attachment flange on the bucket.
Lift loader a few inches and roll the bucket back.
3.
Move latching handles into LOCKED position
(DOWN – handles must be horizontal).
The lockpoins must be extended and secured
into the retaining slots on the bucket.
CAUTION: Before leaving the seat, stop engine
and engage hand brake.
4.
Check proper latching by lowering loader and pushing loader bucket against ground by moving
joystick forward. (Improperly attached bucket would get loose while pushed against ground). Bucket
must be level (in horizontal position) during this check.
T50SS/T50HLSS
6
