JAXJOX JJ15000, User Manual

13

Kettlebell weight is not adjusting. 

•  Ensure the shell is properly seated before adjusting the weight. The unit will 

beep once when properly seated.

•  Verify the weights are stacked correctly, in the right order. Following the 

instructions in the “Assembly” section.

•  The weight of the kettlebell shell may be misaligned with the weight on 

the base. Follow the instructions below in the “Shell and base weight 
misalignment.” section.

KettlebellConnect 2.0 does not beep when the shell is reseated. 

•  When reseating the shell, ensure it is aligned correctly with the base. The 

handles should align with the wings on the base.

•  Ensure the shell is properly seated. It should sit fully against the base, 

without space in between.

•  Verify the weights are stacked in the right order. Follow the instructions in the 

“Assembly” section.

•  The weight of the shell may be misaligned with the weight on the base. 

Follow the instructions below in  the “Shell and base weight misalignment.” 
section.

Shell and base weight misalignment.  

•  Remove the shell from the base.
•  Press and hold the [+] and [-] buttons together 

for 5 seconds, or until you see a “0” displayed 
on the screen.

•  Adjust the display number to the number of 

weights on the base. Example: If there are 
3 weights on the base, then set the display 
number to 3.

•  Reseat the shell on the base. When the unit 

beeps, and weight can be changed properly, 
the shell and base have been realigned.