Receiving your CoolAire Unit
Locate and remove the screws securing the
box to the skid. Lift and save the box incase
a return is necessary. Remove the strapping
and unpack the unit. Inside the tank locate
the following:
1) Atomizing Fan Head
1) Column Assembly
1) Operators Manual/Service Bag
UNPACKING
4
PICTURE OF A
BOXED UP COOLAIRE
UNIT ON A SKID
WHEN AVAILABLE
SETUP
Carbon Fiber
Column (installed)
Lower Hand Hold
Upper Hand Hold
Atomizing Fan Head
Set Up
- Locate your CoolAire unit on a level surface.
- Secure the front wheel locks.
- Install the carbon fiber column and secure
(with thumb screw) at the bottom.
- Grab the two hand holds on the atomizing
fan head and lift atomizing fan head into
position allowing the solid (gray PVC) plug to
slip inside the carbon fiber tube. Align the
dowel pin to fall into the milled slot.
- Secure in place with the second (yellow)
thumb screw provided.
