Manufactured by WISMEC
200W
0.00Ω
0.00V
---F
VW Mode
200W
0.00Ω
0.00V
450F
TC Mode
Wattage Regulation in TC/VW Mode:
In TC/VW mode, output wattage can be adjusted from 1W to 200W. In unlocked
mode, press the up button to increase the wattage and press the down button to
decrease the wattage.
TC Mode:
Temperature Setting: In locked mode, press the up and down buttons
simultaneously until the temperature setting is enlarged. Press the up button to
increase the temperature and press the down button to decrease the
temperature.
Note:
In TC mode, be careful to attach new atomizers that have cooled to room
temperature. If a new atomizer has not cooled down before attaching, the
temperature may read and protect incorrectly until the new atomizer cools.
When you connect a new atomizer or disconnect and reconnect your existing
atomizer, the device will prompt you to confirm this change and a message will
prompt “New Coil? UP YES/DOWN NO”. Press the up button to confirm that a
new atomizer has been attached. Press the down button to confirm that the
same atomizer has been reconnected.
CHECK
ATOMIZER
Indication and Protection
Check Atomizer:
The device does not detect an atomizer,
the atomizer has shorted out, or the atomizer resistance is
incorrect for the power setting.
Shorted:
Check all connections.
Weak Battery:
The battery needs to be charged, or a higher rate battery
needs to be used. If this happens, the Reuleaux will continue to fire the
atomizer, but will not be able to provide the desired wattage. The Weak Battery
message will continue to flash for a few seconds after the end of puff.
Temperature Protected:
The heating coil reached the maximum allowed
temperature during the puff. If this happens, the Reuleaux will continue to fire,
but will not be able to provide the desired wattage.
Ohms Too High:
The resistance of the atomizer coil is too high for the current
wattage setting. If this happens, the Reuleaux will continue to fire, but will not be
able to provide the desired wattage. The Ohms Too High message will continue
to flash for a few seconds after the end of puff.
Ohms Too Low:
The resistance of the atomizer coil is too low for the current
wattage setting. If this happens, the Reuleaux will continue to fire, but will not be
able to provide the desired wattage. The Ohms Too Low message will continue
to flash for a few seconds after the end of puff.
Too Hot:
The Reuleaux has onboard temperature sensing. It will shut down
and display this message if the internal board temperature becomes excessive.
Shift Between TC/VW Mode:
In locked mode, press the up and down buttons simultaneously until the
temperature setting is enlarged. Keep pressing the up button until the sign “OFF”
shows, tap the fire button and you enter the VW mode. In the same way, press
the down button to enter the TC mode.
