USER MANUAL
4
2.3 Remote Controller (For reference only, goods in kind prevail)
Chapter 3 DVR Connection
3.1 HDD Installation
Caution: Please do not take out hard drive when DVR is running!
HDD Installation:
(1) Cut power firstly, and then remove screws on both sides and rear panel and open DVR upper cover.
(2) Connect HDD data line and power line to the main board. Install the HDD to fix it on the bracket
and then connect the HDD power line and data line.
(3) Put the upper cover back carefully
Note: If user requires higher performance HDD, it is strongly recommended to use special hard
drive for security and protection.
3.2 IP Camera and Monitor Connection
DVR video output signals are transmitted to VGA monitor or HDMI monitor by VGA or HDMI
cable and DVR video can be monitored (Refer to section 1.2 Rear Panel). Refer to Chapter 6
System Connection Diagram.
Ite
m
Key title
Key function
1
1-8
Channel select 1-8; Numeric key
2
9
、
0
Numeric key; Clicking numeric “0” allow
you switch to output device
3
ALL
Multiple display mode
4
Menu
Enter into Main menu/Exit
5
Mute
Mute on/off
6
SUBMEN
U
Go to submenu
7
▲
Up arrow key, Volume adjust
8
SEL
Select key/Edit key;
Confirm the selected operation.
9
◄/
Left/Right key,
Decrease/increase parameter value of
control bar
10
▼
Down arrow key, Volume adjust
11
Rewind key
12
Forward key
13
Enter into record search menu;
Play key
14
●
Record key
15
■
Stop manual record; stop playing
16
Pause
Summary of Contents for qv-3146
Page 1: ...USER MANUAL 1...
