SETTING UP YOUR TRAILER
Un-Hitching - Fifth-Wheel Travel Trailer
1. Pull into the site, and park the trailer where you want it.
2. Block the wheels tightly so the trailer will not move.
3. Drop the landing gear (important!!!!). Refer to the manufacturer’s supplied
information for proper operation.
4. Disconnect the 12-volt DC electrical connector and breakaway switch cable
5. Drop the truck tailgate, unless you have a tailgate specially designed to accommodate
a fifth-wheel hitch.
6. Gently put your truck into reverse...(don’t give it any fuel/acceleration).
This effectively moves the kingpin off the locking bar which will allow you to easily
disengage it.
7. Step on brake and apply parking brake.
8. Disengage the locking bar and unhitch.
9. Drive away.
10. Raise truck tailgate, if applicable.
11. Adjust the fifth-wheel height for proper front to back leveling of the trailer.
Un-Hitching - Conventional Travel Trailer
1. Position the trailer as desired.
2. Level the trailer (side to side). Refer the leveling paragraph below.
3. Block the wheels to prevent the trailer from rolling.
4. Unhook the trailer/tow vehicle electrical connection, safety chains and breakaway
switch cable (if applicable).
5. Install the dolly wheel.
6. Release the weigh distributing bars as recommended by the hitch supplier.
7. Open the coupler latch.
8. Turn the jack crank to raise the coupler above the hitch ball.
9. Level the trailer (front to back) with the jack crank.
10. Lower the stabilizer jacks (if applicable). Refer to the steps below.
11. Pull the tow vehicle away, as desired.
28
Setting Up Camp...
Summary of Contents for 2004 Conventional Travel
