JAYCO TOWABLE SECTION 8-PLUMBING SYSTEMS
5.
Drain the sink by removing the drain cap.
6.
Turn ON the water pump and allow it to run as needed.
7.
If the RV water heater has bypass valves: A&B are closed, valve C is open (refer to
the
Water Heater Bypass
section).
8.
Operate the toilet flush lever until water stops flowing.
9.
Relieve the water pressure using the P&T valve BEFORE removing the water heater
drain plug. If there is any water pressure present the water will spray out of the
opening when the drain plug is removed.
10.
Otherwise, if there is any water pressure present the water will spray out of the
opening when the drain plug is removed.
When you are finished draining the fresh water system, reverse these steps and dump the
grey and black water holding tanks at an appropriate facility or according to local public
codes.
It is normal for some liquid to remain in the fresh water tank after drainage procedure.
S
ANITIZING THE
P
LUMBING
S
YSTEM
When to sanitize:
When your RV is new.
At the beginning and end of each season.
When the water system becomes contaminated or every three months of use.
Sanitizing Instructions
1.
Turn both the electric and LP gas water heater switch(s) to OFF. Set the bypass
valves to bypass the water heater; valves A&B closed and valve C open (refer to
Water Heater Bypass Valves
section).
2.
Level the RV and drain the fresh water system. (see
Draining the Fresh Water
System).
3.
Close the low point drain valves and the fresh water tank drain valve.
4.
Full System Canister water filter (if so equipped): Remove the canister; take the filter
out of the canister, then reattach the empty canister.
5.
Prepare a chlorine solution using 1/4 cup of household bleach (sodium hypochlorite
solution) to one gallon (3.785 liters) of water in a container. Prepare one gallon of
solution for every 15 gallons of tank capacity. This will result in a residual chlorine
concentration of 50 ppm in the water system.
If a 100-ppm concentration is required as discussed in step 12, use ½ cup of
household bleach with one gallon of water to prepare the chlorine solution. One
gallon of the solution should be used for each 15 gallons of tank capacity.
NOTE
: Fresh water tank sizes vary by model, contact your dealer or Customer
Service for your specific tank size.
6.
Put the sanitizer solution in the fresh water tank.
Insert one end of a hose in the Gravity Fill inlet, insert the other end into a container
holding the chlorine solution.
Do not use your
non-toxic drinking water hose.
Pour
the chlorine solution into the Gravity Fill.
7.
Remove the hose & container used to pour the chlorine solution, and continue filling
the fresh water tank with clean (potable) water until tank is full:
Pour fresh water into the Gravity Fill inlet until tank is full.
8.
After the recommended amount of sanitizing solution is in the tank, the water tank is
full, and water filter (if so equipped) has been removed:
8-12
Summary of Contents for 2016 Jay Feather
