106
p
lumbing
S
yStem
3 v
Alve
W
Ater
h
eAter
b
ypAss
(i
f
s
o
e
quipped
)
Most floor plans have a factory installed water heater bypass which enables you to avoid
filling the water heater with RV antifreeze. Bypass valves are typically located in close
proximity to the water heater. Outside utility centers (if so equipped) operate differently
than a factory installed bypass system. Refer to the
Outside Utility Center
section for
details.
Factory installed water heater bypass
NOTE:
In the Water Heater Bypass Diagram, valve D is the fresh
water tank shutoff. Valve E is used to introduce RV antifreeze into
the lines when winterizing the system and has a clear hose attached
to it. See Winterizing the Plumbing System in this manual. Valves D
& E are typically located in the vicinity of the water pump which can
be under a dinette bench, kitchen island, or bed.
o
utside
s
hoWer
(i
f
s
o
e
quipped
)
A handheld shower assembly with both hot and cold water may be included for use outside
of your recreation vehicle.
1. Be sure the water heater is ON and had sufficient time to heat the water.
2. Open the outside shower compartment door.
3. If dry camping, be sure the 12-volt water pump is ON.
4. Remove the handheld shower from its holder.
Summary of Contents for 2016 Melbourne
