Jayco EAGLE FW 2020 Owner'S Manual Download

Page: 106 / 201

Section 7: Fuel & Propane System

104

The position of the propane container(s) and the hoses are critical to proper operation and

propane flow. Follow these instructions to make sure your propane container(s) are con

nected properly.

LP Gas Container Overfill

Never allow your propane tank to be filled above the maximum safe

level as indicated by the fixed liquid level gauge. Do not allow the

visible gauge to be used for filling. Overfilling the propane con

tainer above the liquid capacity indicated on the container, could
allow liquid propane to enter the system that is designed for vapor
only creating a hazardous condition.

This label should be kept permanently affixed to your RV.

Refer to your Warranty Packet for more information on the LP gas
system components.

Maintenance

Propane gas is normally non-corrosive - you need not worry about
the inside of your container. However, the outside should be kept

free from rust by a periodic coat of paint in a light reflective color.

Rust, scratches and/or dents can affect the safety of the cylinder.

Inspect the cylinder at regular intervals.

Ifs a problem, have it evaluated by a qualified technician and discard it. DOT requires that a

visual inspection be made prior to each filling.
Any cylinder that has been exposed to fire, leaks or seems damaged should not be refilled.

Do not attempt to repair any containers, container valves, regulator or appliances by your-

self. Use only trained certified propane gas service technicians to perform repairs.

Propane Cylinder Recertification

DOT cylinders may only be used for 12 years after their manufacture date (the number of

years for certification may vary in your area). After that, the cylinders must be “recertified”

which provides another five years of use.
The cylinders can be recertified every five years thereafter. Federal DOT (Department of

Transportation) regulations require periodic inspections and re-qualifications of the propane

cylinders. DO NOT USE damaged or rusted containers.

Verify with your local propane dealer that all required inspections and certifications have

been completed on the propane cylinder within the correct time period before refilling the

cylinder. Have the LP system checked for leakage each time a cylinder is refilled or after

any part of the propane system has been disconnected.

Hoses, Pipes, Tubes and Fittings

The hoses, pipes, tubes and fittings used in your propane system are designed to withstand

pressures exceeding those of the propane system. However, because environment and time
can both contribute to the deterioration of these components, they must be inspected for
wear at regular intervals.

Be sure to inspect the hose before each season and when having the tank refilled. Look for

signs of deterioration such as cracks or loss of flexibility. When replacing the hose or other

propane components, make sure to always replace them with components of the same type
and rating (check with your dealer).

Fittings are used to connect the various system components to each other. The P.O.L. fitting

at the end of the propane supply hose is made of brass so that pipe sealants are not necessary
to prevent leaking.

“Do not fill to more

than 80%” Label

(label appearance

may not be exact)