Section 8: Plumbing System
141
•
Power to the water heater is OFF.
•
Water filter has been bypassed or removed (depends on model).
•
Sanitizer has been put into the tank.
•
Water tank is full having been topped off with fresh water.
12. Set the valves to the
DRY CAMPING
setting.
Green valve points down
Blue valve points to the right
Water Heater Bypass valve is still set to
BYPASS
.
13.
Turn the water pump ON and sanitized water will flow into the water lines from the
water tank (when a fixture is opened).
14.
Open hot water faucets one by one until water begins to flow continuously and a chlo
-
rine smell is noticeable. Close hot water faucets. Repeat this process with the cold
water faucets. Include outside shower faucets (if so equipped) and outside kitchen
faucets as well (if equipped).
15. Turn OFF the water pump.
16. Let the solution remain in the tank and lines for at least four hours when disinfecting
with 50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM
chlorine concentration should be permitted to sit in the system for at least one hour.
17. After the required period, drain the chlorine solution from the fresh water system.
Rinse the system with fresh water:
1.
Fill the fresh water tank full of clean (potable) water. Use water either from a pressur-
ized source, or from a container (as detailed below).
a).
Filling from a pressurized source:
Attach your fresh water
hose to the CITY WATER CONNECTION inlet at the utility
center. Connect the other end of the hose to a pressurized
water source. Colored valves should be in the TANK FILL
position. Turn the water on and finish filling the water tank
with fresh water.
DO NOT OVERFILL THE TANK!
Use
the LED indicators on the tank monitor inside the RV at the
Command Center panel to monitor water level in fresh water
tank.
b).
Syphon filling from a water container
: Fresh water hose
should be connected to the SANITIZE inlet, other end of the
hose placed in a bucket of water. Colored valves should be
in SANITIZE position. Turn the pump ON and water will
be siphoned into the tank.
DO NOT OVERFILL THE
TANK!
Use the LED indicators on the tank monitor at the
Command Center to monitor water level in fresh water tank.
2.
Power to water heater should be OFF (electric and LP Gas switches
on standard storage water heater). Set the red water heater bypass
lever to
NORMAL
. (lever points left)
NOTE:
To thoroughly sanitize the fresh water tank, the unit should be
driven around for a short distance allowing the solution to splash the sides
and top of the tank.
Summary of Contents for Eagle FW 2021
