Refer to the “Utility & Systems” chapter for complete instructions on sanitizing, and the
“Storage” chapter for complete instructions on winterizing, the plumbing system.
NON-BASEMENT WATER SYSTEM
If your motorhome is not equipped with a basement water system, refer to the diagram on
the following pages that is specific to your unit. The diagram provides basic valve location
and a table of information to show how to position the valves for system operation. If you
have further questions, consult with your independent, authorized dealer.
To utilize the campground water direct to your system
1. Connect a hose from the campground water source to the city water connection.
2. Place the valves in the proper position as designated by the diagram of your unit’s
water lines.
3. If hot water is desired, make sure the valves are set so water will flow through the
water heater.
4. Turn on the water.
5. Water will be supplied to all faucets.
To fill the on board fresh water tank
1. Connect a hose from an outside water source to the city water connection.
2. Place the valves in the proper position as designated by the diagram of your unit’s
water lines.
3. Turn on the water.
4. Water will flow to the fresh water tank.
Caution: Be careful not to overfill the tank. It can pressurize the tank, causing
leakage and water damage and void the warranty. DO NOT leave the tank
unattended while filling.
To fill the on board fresh water tank when dry camping
1. Set the valves in the proper position as designated by the diagram from your unit’s
water lines.
2. Place the clear hose in the water container holding the water to be pumped into
your tank.
3. Turn on the demand pump to pump water into the tank.
4. Monitor the filling process and make sure the tank is not overfilled. Turn off the
pump when the tank is filled.
Caution: Be careful not to overfill the tank. It can pressurize the tank, causing
leakage and water damage and void the warranty. DO NOT leave the tank
unattended while filling.
To utilize water from the fresh water tank
1. Place the valves as designated for the pump operation setting.
2. If hot water is desired, make sure the valves are set so water will flow through the
water heater.
3. Turn on the demand pump from the switch located inside the unit.
4. Water will be pumped from the fresh water tank to all faucets.
Granite Ridge/Greyhawk/Escapade Type C Motorhome
41
Setting Up Camp...
Summary of Contents for Granite Ridge Greyhawk Escapade 2005
